Boat Lift and PWC Lift Installation at Lake of the Ozarks
Boat lifts at Lake of the Ozarks are usually hydraulic or electric, sized to the boat's loaded weight. National guides put lifts at $2,000 to $20,000. Adding one is an Ameren modification needing a $550 permit, and the wiring needs GFCI twist-lock outlets and a fire district inspection. Call (573) 410-4467 for installation.
Call and we will connect you with an independent local provider.
CALL NOW: (573) 410-4467Keeping a boat out of the water when it is not in use protects the hull, the lower unit and the bottom paint, and it keeps wake from beating the boat against the slip. That is why most covered slips at Lake of the Ozarks have a lift. Call (573) 410-4467 to reach an independent dock builder who installs lifts at the lake. Lake of the Ozarks Dock Pros is an independent referral service. We do not build docks; we connect you with an independent Ameren Missouri Certified Dock Builder who quotes, permits and builds the job.
Types of lifts
- Hydraulic boat lifts. Common on floating docks; a pump raises and lowers the cradle.
- Electric cable lifts. Winches and cables lift the boat, often on fixed or heavier docks.
- PWC lifts. Small lifts for one or two personal watercraft.
- Drive-on ports. Floating ports you drive a jet ski onto, with no motor at all.
Sizing a lift
A lift is rated by weight. Use the boat's dry weight plus fuel, water, batteries and gear, and leave a margin. A wakeboat with full ballast tanks weighs far more than its brochure dry weight. The lift also has to fit the slip width and length, and the roof has to clear the boat at full lift height, which is why lifts and roof raises often go together.
Lifts count toward your dock size
Ameren measures a dock's total surface area including boat slips and attached lifts. A lift added to an existing dock is a modification, which needs an Ameren permit and a $550 fee and must be installed by an Ameren Certified Dock Builder or the owner. If the lift pushes the dock over 3,000 square feet, an annual fee of $0.06 per square foot applies.
Power and wiring
Most lifts need power, and power at the dock is where the danger is. Ameren's dock wiring checklist requires outlets dedicated to a piece of equipment to be marine twist-lock and GFCI protected, a disconnect within 30 inches of the outlet or an approved pedestal, liquid-tight flexible conduit at pivot points and #6 bonding jumpers across pivots and stiff arms. A dock with power needs a fire district electrical permit and inspection, so the lift should be wired by a licensed electrician.
Typical lift costs
| Item | National-guide range |
|---|---|
| Boat lift | $2,000 to $20,000 (average about $8,000) |
| Ameren modification permit | $550 |
| Fire district electrical permit | Fee set by the local district |
Large hydraulic lifts for heavy wakeboats and cruisers sit at the top of that range or above. Installation, wiring and any slip changes are extra.
What drives the price
- Capacity. Heavier boats need bigger cylinders, cradles and pumps.
- Slip changes. Some lifts need a slip widened or the roof raised.
- Power. Running a new circuit to the dock adds electrical work and inspection.
- Extras. Remote controls, canopy covers and bunk upgrades.
Seasonal care
Lifts take a beating from summer use and winter cold. Before the season, have the hydraulic lines, cables, bunks and electrical connections checked. If a lift creeps down, leaks fluid or trips a breaker, stop using it until it is serviced.
How long it takes
Once the lift is in stock and the permit is in hand, installation usually takes a day or two. Electrical work and the fire district inspection can add a few days. Spring is the busiest time, so order early.
Lift safety tips
- Never stand or swim under a raised boat or under the cradle.
- Keep the lift raised only when the boat is on it, and lower an empty cradle before storms.
- Shut off the lift power before anyone works on the dock or swims nearby.
- Check that the GFCI on the lift outlet trips when tested, as Ameren's checklist expects.
- Watch for oil sheen near hydraulic lifts; a leak means it is time for service.
- Tie the boat down on the lift when strong storms are forecast, since wind can push a boat on a raised cradle.
Questions to ask
- What lift capacity do you recommend for my boat fully loaded?
- Will the lift fit my slip and clear my roof at full height?
- Who files the Ameren permit and the electrical permit?
- What warranty covers the lift and the installation?
Read our dock cost guide for more on pricing, or call (573) 410-4467 to get connected.
Call and we will connect you with an independent local provider.
CALL NOW: (573) 410-4467Frequently asked questions
How much does a boat lift cost at Lake of the Ozarks?
National cost guides put boat lifts at $2,000 to $20,000, averaging about $8,000, before installation, wiring and permits. Heavy wakeboat lifts cost more.
Does adding a boat lift need a permit?
Yes. Ameren counts attached lifts in the dock's size, so adding one is a modification that needs a permit and a $550 fee.
Does a lift need special wiring?
Yes. Ameren's checklist requires GFCI-protected marine twist-lock outlets for equipment and a nearby disconnect, and docks with power need a fire district inspection.
Areas we serve
We connect callers across Lake of the Ozarks, Missouri (Camden, Miller, Morgan and Benton counties), including:
- Osage Beach
- Lake Ozark
- Camdenton
- Sunrise Beach
- Laurie
- Gravois Mills
- Village of Four Seasons
- Linn Creek
- Eldon
- Rocky Mount
- Camden County
- Miller County
- Morgan County
- Benton County
Local pages: Osage Beach, Lake Ozark, Camdenton.
Related services
- New Dock Construction
- Dock Repair & Re-Foaming
- Dock Remodels & Additions
- Seawalls & Shoreline
- Dock Removal & Moving
Call and we will connect you with an independent local provider.
CALL NOW: (573) 410-4467